Ruler

Dec 27

AllAboutAppsHelp No Comments

How to use the ruler video.

To measure your object, start measuring from the left and move to the right side of the object.
Step1: Initialize the ruler by tapping the “Clear Button”
Step 2: Put your left-end side of the ruler screen to the left-most end side of the object to measure.
Step 3: Place the “Needle” so it points at the initial position of 2.50 inches or move to the right-most side of the screen.
Step 4: Place your index finger on the needle point position.
Step 5: Move the left-end side of the screen of the ruler to match your index finger.
Step 6: Tap the “Plus Button” to set base position to moved location.
Keep repeating steps 4,5 and 6 until the very right-end of the object is located inside the screen.
Once the end of object is located within the iPhone or iPod touch screen, move the ”Needle” to the right end-point of the object, and read the number panel for the measurement.

Clear Button: It will reset the ruler.
Change Ruler Direction
Alternate “cm” and “inches”.
This button can measure up till the chosen measurement point and keep adding this same measurement amount from that chosen point of the current screen to the needle point or until the end point of the object.
The “Exit” button
This is the “needle,” where the number points.

Comments are closed.